Feeder Button Mode for X4BT

1. When the printer is not running, press the feeder button once and release it, Aobio will feed a blank page.

2. When the printer is running, press the feeder button once to pause. Press once again to resume the print job. (If you need to cancel an unfinished print task. Please turn off the printer power and cancel the print task from the computer at the same time.) 

3. For each time you change the label in different sizes, please press the feeder button for about 3 seconds until you hear one beep to run the Intelligent Label Study process.

4. Press and hold the feeder button for about 5 seconds until you hear two beeps. Aobio will print a test page. If the test print looks good, it indicates that the printer head is working properly.

5. Press and hold the top button for about 15 seconds until you hear three beeps. This will restore Aobio printer to the factory settings.